View Single Post
Old Sep 26, 2012, 08:43 AM
Haych is offline
Find More Posts by Haych
Registered User
Australia, VIC, Melbourne
Joined Mar 2010
484 Posts
Quote:
Originally Posted by Del-Dredd View Post
Using flashed ESC's on mine and still get the beeps with no motor spinning during calibration.
TX at full Throttle, connect battery and hold buttons 1 & 4 down, get beep then lower throttle to min, get another beep, then switch off.

Have you checked on Rx Test that throttle is operating in the correct sense ie 0 at min throt and 100 plus at full throt.

If using V1.0 you have to have butoons down when connecting battery.
Hi, thanks for the reply.

Yes, I flashed my mates KK2 and his did the correct beeps, he uses Plush, I use RCTimer...

my throttle is set right, it even flies right, (tricopter) its just this calibration that I cant get to do what I want it to do.

I just flashed to Shanes Rev2 F/W from KK2 1.2 previously, both respond the same with calibration...
Haych is offline Find More Posts by Haych
Reply With Quote