Thread: New Product xRotor IFrame Clear View FPV
View Single Post
Old Sep 25, 2012, 04:45 PM
TaSaJaRa is offline
Find More Posts by TaSaJaRa
More props are better than One
TaSaJaRa's Avatar
United States, AL
Joined Nov 2004
2,200 Posts
More Progress...

I got all my arms cut today and drilled for screws. I will add a few more screws to the top after I get through putting clear on the IFrame.
My arms are just a bit longer than suggested size. I am planning on using a 9" props.

I also drilled the center plate to accept my control board. You may already do this but for the ones that don't....
I take a 3/32 drill bit and drill a pilot hole, then run a M3 metal screw in and out of the hole a few times. This will make the nylon standoffs screw in a bit easier, which support my MultiWII board.
TaSaJaRa is offline Find More Posts by TaSaJaRa
Reply With Quote