View Single Post
Old Sep 25, 2012, 10:25 AM
blueprint is offline
Find More Posts by blueprint
FPV Pilot
blueprint's Avatar
United States, CA, Los Angeles
Joined Sep 2007
2,534 Posts
Quote:
Originally Posted by Cervanchez View Post
Hey guys

So I was finally just getting my HT-FPV dialed when a bad factory motor solder took me out. Here's a quick video of me messing around before it went down. unfortunately I didn't catch the crash on film.

Frame: HT-FPV
Flight Controller: Naza+gps
Power Distribution: homemade
Batteries: 3300, 4000 mah 3S and 4S
ESC: DJI 30A optos
Motors: DJI 2212
Props: 8-9" various
Rx: Frsky D8RX
Lights: n/a
Camera: sony 540 tvl
Video Tx: 400mW 1300MHz
OSD: Eagle tree
AUW: ~1600g
Are u having any interference with your 1.3ghz VTX and frsky? I could not get over a mile without mine going into fail safe. On 5.8ghz i can get well over 1.5 miles before i get any beeps.
blueprint is offline Find More Posts by blueprint
Reply With Quote