Thread: Discussion Fy-31ap
View Single Post
Old Sep 25, 2012, 05:41 AM
Chris in Oz is offline
Find More Posts by Chris in Oz
Registered User
Australia, WA, Perth
Joined Jul 2012
122 Posts
Reading into it further it seerms the FY 31AP should be pre programmed for a certain height. Has anyone had a similar problem where the elevator goes into UP position when turned on to RTL or ACM, but works fine on ABM. I have read the manual but not sure that GCS is the answer, but I am keen to find out what needs to be done to get it right. It was fine, just suddenly changed the other day after having worked fine on a number of occasions previously. Any help or suggestions welcome, cheers.
Chris in Oz is offline Find More Posts by Chris in Oz
Reply With Quote