View Single Post
Old Sep 24, 2012, 09:36 PM
IntegrityHndywrk is offline
Find More Posts by IntegrityHndywrk
IHW Heli Division
IntegrityHndywrk's Avatar
United States, FL, Palm Coast
Joined Mar 2012
8,565 Posts
Savox Servo, Electronics Install + Swash leveling

Savox Servo, Electronics Install + Swash & follower leveling

The following info will be basic install info on the install of the Savox servos using one stock ball link and 2 Blade 450 (long) links and basic electronics. Many people have done videos and posted their settings for the 2702V and how to actually do the end points setup and all of that. I may cover the actual 2702V setup at a later time.

I will also show some images and basics of the swash leveling and how i set my pitch to zero (loosely) without using a pitch gauge. Plus maybe a few other things.


UPDATE 01/01/13:
I figure maybe i should put some information here about the electronics I'm using and some of the setup data for this build.


CopterX 430XL 3550kv motor.

8 Poles
3550kv
3.5mm shaft
Using a 13T pinion.

Hobbywing Skywalker 40A ESC.
Changed the below settings.

Breaking: OFF!
Start Mode: Soft
Timing: Low

Hobbywing Platinum Pro 40A ESC.
Changed the below settings.

Start mode: Soft
Timing: 7.5
Governor mode: Off or High (TX must be setup for gov mode. Otherwise leave off. More on that later)
PWM Frequency: 8kHz
Bec Output: 6V
IntegrityHndywrk is offline Find More Posts by IntegrityHndywrk
Last edited by IntegrityHndywrk; Jan 09, 2013 at 09:50 PM.
Reply With Quote