View Single Post
Old Sep 24, 2012, 08:19 PM
Guru06 is offline
Find More Posts by Guru06
Registered User
United States, NC, Raleigh
Joined Mar 2012
198 Posts
Discussion
KK 3.0 Board Won't Arm or Calibrate

Hellooo everyone, I finally have all I need to get in the air with my hex and now its down to configurations.

A little background info on what I have done:
I have a 9x with a Smartieboard and ER9X and Parkeflyer config thanks to their great install video. The receiver is binded properly to the best of knowledge, no blinking led. Ch1 to AIL, Ch2 to ELE, Ch3 to THR and Ch4 to RUD, black cables to the outside, white to the inside of the kk board. All 6 motors plugged in the same way white to the inside black to the outside.

I tried to calibrate the ESC all at once by turning YAW all the way to the right but didn't have any luck. So I unplugged each one and put them into Ch3 and I was able to calibrate. I have done the ESC programing with the programing card. When I get to Stick Centering on the setup manual http://www.kkmulticopter.kr/index.html?modea=manual I get nothing. I am using 1.6j by Mike Barton if that matters. When I plug in my battery all the ESCs beep and the motors jiggle a little bit.

Thanks for any assistance, I searched and tried most of the options that made sense so I decided to start my own thread. Again thank you for your help.

Guru06 is offline Find More Posts by Guru06
Reply With Quote