View Single Post
Old Sep 24, 2012, 06:43 AM
iflyhelis is offline
Find More Posts by iflyhelis
Semi Expert
iflyhelis's Avatar
United States, MA, Norton
Joined Aug 2012
292 Posts
From what I read, that switch 1 to ADJ mode is only there for you to adjust the linkages & servo arms to get the swash-plate perfectly level. Then you flip the switch back to WK & re-initialize TX & RX. I think that if you do a adjustment mechanically without using the switch, you will run into a binding problem or burn out a servo or the RX.

When in the ADJ mode of switch 1 I think the gyro/RX is sensing your adjustment & holds that setting in memory.

I hated to do it, but I just used sub-trims to level mine out instead of going through all the crap of trying to remove the fore/aft cyclic ball linkage.




Quote:
Originally Posted by Acunamatata View Post
Same problem, in the instruction you need to select normal swash type so no mix swash for adjustments... and I can't understand how to get the RX to a FBL setting mode! in the ADJ mode switch appear as gyro disable and not FBL setting mode.
in the older RX's you have a setting button, but in the new 2703 I can't figure it out!!!

I'm the second that have the new RX2703 with the same issue!

please any one can figure it?
iflyhelis is offline Find More Posts by iflyhelis
Reply With Quote