View Single Post
Old Jun 15, 2004, 12:31 PM
olmod is offline
Find More Posts by olmod
Good Better Best quest.
olmod's Avatar
Australia, VIC, Langwarrin
Joined Apr 2004
10,589 Posts
Want a tight fit?

Try going through your collection of shafts with a micrometer and select the smallest diameter,carefully grind a radius on the end then with a dremel grinder grind across halfway up just past the radius,you will have what is known as a D bit,it acts like a cross between a drill and a reamer,of course you will have to drill a pilot hole first before using the D bit use slow speed and metho' as a coolant lubricator.and so long as you dont keep it spinning in the hole to long you should have a press fit.
olmod is offline Find More Posts by olmod
Last edited by olmod; Dec 07, 2006 at 02:24 PM.
Reply With Quote