Thread: Discussion Multiplex Fun Cub
View Single Post
Old Sep 19, 2012, 02:47 PM
Del-Dredd is offline
Find More Posts by Del-Dredd
Registered User
Del-Dredd's Avatar
Near Aberystwyth - Wales
Joined Aug 2004
2,134 Posts
Quote:
Originally Posted by marksp View Post
When I recently pulled my Himax HC3516, I noticed the wire insulation had interfered with the spinning can. I'm replacing with the EMax GT2812/10 which is also a 35mm diameter motor.

Any motor wire routing tips/pictures to make certain of no interference?

Thanks
As Bluhammer did and a few others, I cut a slot through into the air intake channel, motor wires go straight into there and then back to ESC, no need to overstress the wire with a bend near its minimum bend radius and less likelyhood of wire fracture at some point.
Del-Dredd is offline Find More Posts by Del-Dredd
Reply With Quote