Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Sep 18, 2012, 08:21 PM
tom-tom 1 is offline
Find More Posts by tom-tom 1
Registered User
Joined Jun 2010
61 Posts
WELL! I don't know what is going wrong. I still can't get the board to work.

I've used both arduino 22 and arduino 23. I have loaded MultiWiiV1_7 with both. I got the port COM4 open. The message says the upload was done. I open the conf. file which downloaded with the MultiWiiV1_7, and then nothing! The GUI does nothing. I click on the port, read, write, calibrate, start and all I get is a straight line graph. I installed the board in the QTR and............................... NOTHING.
tom-tom 1 is offline Find More Posts by tom-tom 1
Reply With Quote