Thread: Discussion New X8 WING
View Single Post
Old Sep 18, 2012, 08:13 PM
deTonaTor_NZ is offline
Find More Posts by deTonaTor_NZ
Religion= suffering/wars
deTonaTor_NZ's Avatar
Joined Jan 2006
282 Posts
Quote:
Originally Posted by Imagecatcher View Post
Regarding friction, I have used two linear bearings (CNC table bearings) so it slides quite well. The friction is mainly from the black polyeth block that acts as an anti roll guide. The bearings are mounted in a plastic race so that may wear too. My objective was to be light and avoid two runs of Ali But it may prove false economy.
Do you have adjustment in your bearings t clamp onto the rail as it wears?
looking forward to seeing your maiden TO
Troy
No bearing adjustment though I can skim the plastic spacer if necessary, I'm not expecting wear to be an issue after anodizing.
deTonaTor_NZ is offline Find More Posts by deTonaTor_NZ
Reply With Quote