View Single Post
Old Sep 17, 2012, 03:17 AM
JayNZ is offline
Find More Posts by JayNZ
Registered User
Joined Mar 2012
222 Posts
Quote:
Originally Posted by Choppercopter View Post
Does any of you guy know how to detach or remove the torque tube end tip from the torque tube? I need to use those tips to make new torque tube.

If there is any of you guys know how, please show me. I need to make the 3 lengths torque tube for this conversion from the Align torque tubes. I don't think Kin will get the bended tubes replaced for me so I guess I have make them myself.

Any guys know please help.

Thanks
from memory, i was able to unscrew an align tip and reuse. if that fails, just grind a slit along the tube with a thin dremel cutting disk and part the tube with a screwdriver and the tip should loosen and you can pop it out.

The smartmodel raised tail system should come with a drill bit, and 8 littlle pin shafts. insert your tips into torque tube, put in a vice and drill through them, instert the pin shaft and then grind the outer tips of the shaft down a little to allow the tip to be inserted into the torque gear.

the instructions can be viewed/downloaded an kins site.
JayNZ is offline Find More Posts by JayNZ
Reply With Quote