Originally Posted by bubbleman
Help, I need a way to slave a second channel to the CH 6 control. The FunCub requires that one flap servo be reversed. Anton
Given the numerous set ups for one of those models, would need to know how other channels
are being used and which are still free.
All knowledge on mixes is available under:
Hitec Eclipse & Eclipse 7 Pro - All Manuals, Addenda, Quick Setup, CCPM and Additional Programming FAQ
However, rather than trying to slave a second channel, there are also several other methods to install
your MPX Funcub as shown on previous thread:
. Multiplex Easy Cub & Fun Cub - Aileron, Elevator & Flaps Installation
. Multiplex Easy Cub & Fun Cub - Install Aileron & Elevator - Video
note re video
- see pic attached.
"Easiest general purpose solution:
"Multiplex Easy Cub & Fun Cub - Install Aileron & Elevator - Video"
. 3.35 minutes into video is highlighted "Flap Servos on a "Y" Connector".
This describes enlarging one hole sideways so as to flip the servo over and
mount flap horn further over to compensate, refer attached screenshot..
. Size the section of wing to be removed so as to glue as a filler in the original hole.
. Multiplex Easycub questions
. Multiplex Easy/Fun Cub Aileron
. Differential - Mechanical set-up
- Correct Dutch roll and Drag. "
This may also be of interest:
MPX Easy/Fun Cub Tailwheel Assembly & Replacement.
and more under
Alan's Hobby, Model & RC FAQ Web Links