View Single Post
Old Sep 15, 2012, 10:19 PM
invertmast is online now
Find More Posts by invertmast
Registered User
United States, FL, North Port
Joined Mar 2004
3,812 Posts
Laid out the position of the upper drag rudder on the left wing panel. I'll probably glass this area soon as it needs cut out before the bottom gets sheeted, and I don't want to ding the edges of it, or I may get some extremely thin (.005" or less) G-10 and laminate it around the opening instead.




And then there were two! Sheeting will happen tomorrow (un-likely) or later in the week, as I am waiting on the wing tubes to arrive as they must be installed before the bottom is sheeted as well.. But I can still make up the rib to wing tube doublers.a


invertmast is online now Find More Posts by invertmast
Reply With Quote