Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Sep 15, 2012, 05:56 PM
tom-tom 1 is offline
Find More Posts by tom-tom 1
Registered User
Joined Jun 2010
61 Posts
Well here I am with a new board, new bigger motors and can not get the v1.7 code from this thread to load. I am getting "cannot find com 3 port" messages. I can't select com port 3 because my "tools" "select port" will not light up to allow me to select serial port com 3. I ran into this problem another time but I can't remember what I did to correct it. I couldn't get that board to work either. If anyone has some helpful suggestions, I would really appreciate some help. I'm getting pretty frustrated.
tom-tom 1 is offline Find More Posts by tom-tom 1
Reply With Quote