Thread: Discussion Zig Zag Racer 3 conversion
View Single Post
Old Sep 14, 2012, 02:58 PM
s_berri is offline
Find More Posts by s_berri
Registered User
Joined Oct 2010
1 Posts
Same issue here with all five of my Zig Zag 3(s). I was able to get into programming mode for the ESC,rather easily, but that was it. The beeping sequence just kept repeating itself regardless of what TX commands I tried. I've spent countless hours researching the ESC/RX brick in the Zig Zag 3. Parkzone and Hobbyzone use what physically appear to be the same unit covered in a folded plastic to drive some of their airplanes. However, these ESC/RX(s) have an Atmel chip onboard which means the sky is the limit as to what functionality may or may not be programmed into these bricks. My advise, run them until the burn out and replace them with a Seaking 35 Amp BL esc, Tacon BL motor, and GT3C from Hobbypartz. That's my path if the LHS doesn't have what I need this afternoon.
s_berri is offline Find More Posts by s_berri
Reply With Quote