Thread: Discussion 3DHS Fanatics!
View Single Post
Old Sep 12, 2012, 04:36 PM
REXBIRK is offline
Find More Posts by REXBIRK
Registered User
United States, OH, Columbus
Joined Apr 2009
150 Posts
Quote:
Originally Posted by goflyhighrc View Post
I take meshed drywall tape line the inside of the wheel pants, then a thin coat of Gorilla Glue. I just run water from a faucet inside the pants wet them good then shake the water out then brush the GG glue over the meshed tape. The GG glue expands to app 1/4 inch thick and just adds a couple of grams to each pant. Haven't cracked a pant since. I also use 2mm blind nuts and bolts vs. the screws on the landing gear. Other guys at my field have used the meshed tape and epoxy they are much more durable than stock but they still crack a bit. Gorrill Glue over the mesh holds yet is flexible.Done this on my 51 -70 and 89 Slicks. You won't be dissapointed.

http://www.toolup.com/marshalltown_m...FQjZQgodjVgAUg
Great idea! I will try that! I will add a block on the outside for the axle to fit in also. Wonderful ideas guys!
REXBIRK is offline Find More Posts by REXBIRK
Reply With Quote