Thread: Help! Wing ID Needed - Stork?
View Single Post
Old Sep 12, 2012, 09:21 AM
jkettu is offline
Find More Posts by jkettu
Registered User
Joensuu, Finland
Joined Mar 2002
1,751 Posts
Well, there are some differences to mine - the tip shape is slightly different and my joiner blades have a couple of degrees dihedral built-in. But there are several versions of Stork, maybe yours is just a different variant. The following data applies to a Stork 4 electric, x-tail.

Panel length: 930 mm = 36.61"
Profile thickness at root: 18.7 mm = 0.74"
Wing chord at root, including aileron: 221 mm = 8.7"
Incidence pin diameter: 3.0 mm = 0.12"
Distance between incidence pins, center to center: 123.5 mm = 4.86"
Distance from leading edge to center of front pin: 16 mm = 0.63"
Distance from wing bottom surface to center of front pin: 8.0 mm = 0.31"
Distance from wing bottom surface to center of rear pin: 9.0 mm = 0.35"
Distance from leading edge to front face of wing joiner: 73 mm = 2.87"
Distance from wing bottom surface to bottom of wing joiner: 3.1 mm = 0.12"
Wing joiner dimensions: 9 mm x 12 mm = 0.35" x 0.47"

Manufacturer's home page: http://www.heinrich.sk/index.html

Hope this helps.
jkettu is offline Find More Posts by jkettu
Reply With Quote