View Single Post
Old Sep 12, 2012, 05:21 AM
Makdaddy is offline
Find More Posts by Makdaddy
Doink-not again :)...aka Greg
Makdaddy's Avatar
United States, MI, Sterling Heights
Joined Jul 2012
1,508 Posts
Quote:
Originally Posted by Ribble View Post
When a tail motor dies, I cut the wires at the tail motor, replace the tail motor, scrape the enamel off the wires. and solder.

When a tail boom breaks, I wrap it with paper towel and superglue the whole mess.

If you put the tail motor wires on the outside of the tail boom, nail polish is good to hold it and protect the wires.

A product called Un-Cure is a debonder that turns the cyanoacrylate (CA) glue into a gel, but you have to keep poking the glued part, wiping, adding more Un-Cure.
http://www.hobbyking.com/hobbyking/s...idProduct=8458
I found using my wife's acetone nail polish remover to work quite well for debonding. Fancy stuff from the nail pro store.
Makdaddy is offline Find More Posts by Makdaddy
Reply With Quote