View Single Post
Old Sep 11, 2012, 07:30 PM
Ribble is offline
Find More Posts by Ribble
Crash and learn
United States, PA
Joined Dec 2011
2,852 Posts
Quote:
Originally Posted by john631 View Post
I replaced the boom and the tail motor
When a tail motor dies, I cut the wires at the tail motor, replace the tail motor, scrape the enamel off the wires. and solder.

When a tail boom breaks, I wrap it with paper towel and superglue the whole mess.

If you put the tail motor wires on the outside of the tail boom, nail polish is good to hold it and protect the wires.

A product called Un-Cure is a debonder that turns the cyanoacrylate (CA) glue into a gel, but you have to keep poking the glued part, wiping, adding more Un-Cure.
http://www.hobbyking.com/hobbyking/s...idProduct=8458
Ribble is offline Find More Posts by Ribble
Reply With Quote