View Single Post
Old Sep 10, 2012, 12:00 PM
iflyhelis is offline
Find More Posts by iflyhelis
Semi Expert
iflyhelis's Avatar
United States, MA, Norton
Joined Aug 2012
292 Posts
Discussion
Walkera Devo 10/RX 2703-H-D Setup Info Needed

I have V450 Do1 V2 Helicopter which came with the Devention 10 TX & also the oddball RX 2703-H-D.

With the newest documents I can find on setting it up, I am confused.

This was a RTF, so I don't get building it info with part numbers & such, no references to anything.

All I am trying to do right now is too adjust the swash plate so it is level.

It looks like I need to disconnect the motor wires (for safety) turn on the TX & bind to my RX. Then flip switch 1 to SW so I can then adjust the servo arms or swash-plate ball-links. Then I need to turn switch 1 back to WK position.

Right now, my forward/aft servo is so far aft that my trim is maxed out & still won't compensate it & hover in one place.

I don't know how many people have a Devo 10 or the RX 2703-H-D on this forum, but from the threads I have been on in the Walkera area, it looks like I might be the 2nd person that has got this equipment on this forum.

If I had a 2702V receiver, I wouldn't have a problem setting it up, but this 2703-H-D is a real pain in the Butt!

Any help would be appreciated.

Thanks in advance!

Kurt
iflyhelis is offline Find More Posts by iflyhelis
Last edited by iflyhelis; Sep 12, 2012 at 05:11 AM.
Reply With Quote