View Single Post
Old Sep 10, 2012, 10:34 AM
Firewolf is offline
Find More Posts by Firewolf
Registered User
Firewolf's Avatar
Heliyork
Joined Nov 2009
84 Posts
Quote:
Originally Posted by Hobbyfuns View Post
Hi firewolf, do you think this 3900kv Hobbymate motor will work on master cp?

http://www.ebay.com/itm/Hobbymate-HB...item2574ed12c2

And a brushless esc will be a necessary with the motor right? How to configure the esc connection on rx, which channel shall the esc goes in? And what how to connect the stock brushed esc, which originally control both main motor and tail

Thanks
I haven't done the conversion myself on master CP but i am pretty sure that bl motor will do the job. Just make sure about its shaft thickness if you are gonna use the stock pinion.

Check this link for bl conversion setup,
http://www.rcgroups.com/forums/showp...&postcount=896
its pretty straight forward. You need a "brushed to brushless" convertor. Here is what i am using in my V400
http://www.miracle-mart.com/store/in...oducts_id=3949



You need to make a Y harness to connect both ESCs to the battery. The three prong wire connector from the brushless esc will connect to the three pins of the signal convertor. The black and red wire at the other end of the convertor will go in to the Main motor connector of the stock walkera brushed esc (the one which was connected to stock brushed motor).
Firewolf is offline Find More Posts by Firewolf
Reply With Quote