Thread: Discussion The Willow's Birthhday
View Single Post
Old Sep 09, 2012, 07:17 AM
RCRod is offline
Find More Posts by RCRod
Acacia II Lunar Lander
RCRod's Avatar
United States, CA, LADERA RANCH
Joined Feb 2011
640 Posts
Originally Posted by Bobbyr View Post
Looking Good Rod ,
I see what your saying about tweaking 1 of them , maybe whip the tail off , heat the solder and get the ball to move , then snip off the excess.
TBH do you think it will affect it when each servos travel is set on the TX ?

I would leave it myself

Thanks, Bob. I could probably wait and work it out in the Tx programming, but I'm going to have the tail back apart to get the linkages bonded to the pushrods, anyway. A minute with the soldering iron, and I should have it nice and clean.

RCRod is offline Find More Posts by RCRod
Reply With Quote