View Single Post
Old Sep 08, 2012, 04:24 PM
A.T. is offline
Find More Posts by A.T.
Registered User
Joined Aug 2002
5,811 Posts
Quote:
Originally Posted by relorre View Post
I am newer to flying and just bought a new Tower Hobbies P51. Anyway, I bought the P51 along with a new Hitec Optic 6 Sport 2.4 ghz. I got it all set up last night and then I noticed a couple of problems. For some reason, the motor does not start running until the throttle is thrown halfway. Also, all of the other servos max out before any of the control sticks are maxed out. So I have a dead stick until half throttle, and then dead control sticks after about halfway through their full range. Any ideas? Thanks!
Did you reduce Ch3 trim to 60<80% or even minimum, alternatively adjusted EPA almost to maximum?
Do this prior to set up of any new ESC for each model as an Optic 6 Sport is similar to all othert computerised Tx, refer:
. EPA, ATV, Dual & Triple Rates, Expo Differences & Caution + ESC / BEC Set Up

Further information is available under:
. Hitec Optic 6 & Optic 6 Sport - Manuals, Tutorial, Comparison Charts, Updates & FAQ

Alan T.
Alan's Hobby, Model & RC FAQ Web Links
A.T. is offline Find More Posts by A.T.
Reply With Quote