Thread: Discussion Canterbury J #503
View Single Post
Old Sep 08, 2012, 03:16 PM
Odomtim is offline
Find More Posts by Odomtim
Registered User
Odomtim's Avatar
Hanford, CA
Joined Nov 2008
43 Posts
Hi Jim,

I left the front support the same, but the rear I traced it out then cut the inside out that left two separate pieces that support the curve ov the hull only. This isn't the best picture, but the hull is resting on the base and the rudder is going all the way through and not being touched buy the frame. I will look for a better picture of the cradle.

Tim
Canterbury J #515
Odomtim is offline Find More Posts by Odomtim
Reply With Quote