Thread: Discussion RVOSD - V5 - reports
View Single Post
Old Sep 08, 2012, 02:38 PM
bjornthans is online now
Find More Posts by bjornthans
Registered User
bjornthans's Avatar
Norway, Troms, Skjervoy
Joined Jul 2012
1,022 Posts
hi again. the servo test did not show the problem. tryed different escs also. and the problem still is there. the motor is cutting from 50 % and up. tryed setting endpoints and running the wizard. any ideas folks ?

Originally Posted by Rastislavko View Post
Some digital servos works pretty bad with RVOSD. I met the same problem with INO-LAB HG-D202MG - they jittered as hell. I analyzed the problem on scope and I found that RVOSD output on PWM line is 5Vp-p, but those servos needs lower voltage, they works well on 3.8Vp-p.

This may be also the problem of your ESC - try to connect good and working servo instead of ESC and try what it will do when moving the throttle stick all the way. This is how you can easily find out if the problem is in RVOSD or in your ESC...
bjornthans is online now Find More Posts by bjornthans
Reply With Quote