View Single Post
Old Sep 07, 2012, 05:30 PM
buddertoast is offline
Find More Posts by buddertoast
Registered User
Joined Jun 2008
133 Posts
ok, phasing is fine. there is barely any movement, I mean less than a half of degree pitch on the aligned blades of the tail boom when moving elevator.

My gyro is a sk720. a skookum updated to the latest firmware setup under scale. my. I have lowered my damping gain, but I think it is not my gyro.

When I move stick my swashplate bounces up and down?



I forget what this piece is called, would this cause the bouncing if it was not even both sides? I'm going to try mine from my trex 600 flybarless head and see if that makes a difference.

Nevermind. its not that something is causing my swashplate to bounce rapidly and it's not my gyro as I can hear my servos fighting against it. (the sound you hear if your servo is centered with no tx movement and you try to push the servo horn down).
buddertoast is offline Find More Posts by buddertoast
Last edited by buddertoast; Sep 07, 2012 at 05:52 PM.
Reply With Quote