View Single Post
Old Sep 07, 2012, 04:56 PM
josereyes is offline
Find More Posts by josereyes
Registered User
josereyes's Avatar
United States, WA, Steilacoom
Joined Nov 2011
162 Posts
Originally Posted by buddertoast View Post
Jose, the batts are just loose on the table. there not attached. it's not the batts causing the issue I can assure you. I will check the phasing like you said and see.

So, Jay, you never seen this before. I have hovered it like this and is fine in a hover until I put some movement on it, then is oscillates pretty hard. I had an outrage 450 do this to me way back when, and I never got it right. Sent it back and never left align since.
I have the blades set at 0 pitch all the way from 0 to 100. I was setting up my tracking.

what is a stab? do you mean my sawhorses with a board tied down to it? I emailed the manufacture ( and they asked for a video, so I sent them this one and the one with no blades on it. I think this swash is a little overkill if you ask me. why all the unneeded necessity?e

I wish I had another 4 blade swash to test it with. Man, I might have to leave this head and start over. What a waste of $280 bucks........
Don't discard yet... Check the phasing....
josereyes is offline Find More Posts by josereyes
Reply With Quote