Thread: Build Log Hovercraft SR.N6
View Single Post
Old Sep 07, 2012, 04:51 PM
HoverTim is offline
Find More Posts by HoverTim
Registered User
HoverTim's Avatar
Joined Mar 2007
275 Posts
props

whats the fit like on the prop adapter if its a bit loose then you can wrap some masking tape cut down to about 10 mm wide this allows the prop to sit tight on the shaft and not wobble i would check everything on your lift motor setup as the prop should not sheer off
HoverTim is offline Find More Posts by HoverTim
Reply With Quote