Originally Posted by TucsonFlyer
I put in a set of Futaba 3114s when my V200D03's ELE servo stripped. They're plastic geared and analog but they're almost the same price as the stock servos and much higher quality. I have had a little trouble with the 3114's not holding their subtrim with the RX2618 but they do hold their centers so I just adjust mechanically. It's hard to want to wrench on a disgruntled V200 when I have my T-Rex 250 that's flying perfectly next to it on the shelf
The V200D03 I'll be receiving shortly also has S3114 servos installed. Though the previous owner is giving me the two remaining stock servos, I suspect they'll either end up in the trash or as gear donors if I also pick up one of these. I would think that S3114's should work in the Master CP, particularly since the stock servos are used in both birds.