I've been working on the CAD plans today and noticed some discrepancies and incorrectly drawn parts in the wing ribs. The original designer didn't figure in the wing sheeting for R5 through R27 - ruhro. Easy enough to fix, just takes time to lay it out on the wing plan view and redraw correctly.
The fuselage, skid / skate profile and nose, canopy profile will be adjusted too.
I've also taken the liberty to adjust slightly for conversion to 1/16" balsa sheeting (1.587mm rather than the 1mm drawn) on the wing ribs for us yanks
and will send out the whole lot as a .DWG file for laser cutting to ak-models, wahoo!
This *might* explain why the original builder in the Netherlands doesn't have finished photos and why the project photo progress has stopped right before wing sheeting...