View Single Post
Old Sep 06, 2012, 12:08 PM
buddertoast is offline
Find More Posts by buddertoast
Registered User
Joined Jun 2008
133 Posts
Quote:
Originally Posted by Horseman View Post
Hello all,

After the photo's and explaining from Partick I build my X tail for the Apache.

I have used the front gear unit

and uses a rubber hammer to dismount the crown gear,


Push out the lock pin,

The result,



I have used a 450 main and just glued the crown gear with thin CA.


Jan, did you reuse the lock pin and drill a hole in the 450 shaft, and if so, what size bit did you use?
thanks
Buddy
buddertoast is offline Find More Posts by buddertoast
Reply With Quote