View Single Post
Old Sep 06, 2012, 06:53 AM
zadaw is offline
Find More Posts by zadaw
Hong Kong
Joined Jan 2010
6,382 Posts
Quote:
Originally Posted by Atomic Skull View Post
Was thinking more along the lines of using it in a 250 clone. Could someone maybe just plug a servo into that port and see what it does? If it's a throttle signal then it's just a PPM signal that should drive a servo.

Also has anyone checked the "not used" ports to see if there's any output from those?
I checked with an extra Walkera servo and it will not work with the tail motor port. There does not seem to any output from the used ports either.

The diameter of the main shaft appears to be 3.0mm. It may be possible to use V200D03 parts and vice-versa.
zadaw is offline Find More Posts by zadaw
Reply With Quote