View Single Post
Old Sep 05, 2012, 05:28 PM
billpa is offline
Find More Posts by billpa
billpa's Avatar
Joined Nov 2003
4,949 Posts
Hi Rogwar,

We tried this here today and it worked correctly. :S So, this is a bit of a mystery.

Would you be able to try the following:
a) make sure that the model (actually the guardian unit) is not tilted more than 25 degrees past inverted in any direction (I assume this is the case?)
b) connect the battery
c) observe the control surfaces,and wait until they reach approximately normal trim (no more than 10 seconds)
d) at that point, try the reset gesture
billpa is offline Find More Posts by billpa
Site Sponsor
Reply With Quote