View Single Post
Old Sep 05, 2012, 08:16 AM
Skewp is offline
Find More Posts by Skewp
In progress...
Skewp's Avatar
Estonia, Tartu County, Tartu
Joined Jul 2012
237 Posts
Quote:
Originally Posted by 2400RDR View Post
That's a sweet looking frame on your octo- the quad too. You must have access to a laser cutter.

Can we see some close-ups of those plywood frames?

Rick
Yes, You are correct. All those plywood frames are laser cut from AutoCAD models. I cannot give any close-ups at the moment but I can say a few words about the quad frame. It is made for Turnigy Plush 25A ESC's, RcTimer 750 kV motors and for any 45x45mm flight controller + HK Quad Power Board. There is a special spot for ESC's in the arm that keeps them locked in one place. In the center there is enough space for a 45x45mm power board and flight controller (with Nylon spacers). Motor mounting holes are made so that every motor's wires are faced to the center of the quad. M2M distance is 76 cm. Landing gear is high enough to mount a 5000 mAh battery on the bottom. These is a total of 4 screws used (and no glue).
Skewp is offline Find More Posts by Skewp
Reply With Quote