Thread: New Product announcing the eLogger V4!
View Single Post
Old Sep 05, 2012, 07:06 AM
Jim Blanchfield is offline
Find More Posts by Jim Blanchfield
Registered User
McLean, VA
Joined Dec 2001
297 Posts
Brushed Motor Fwd and Rev Question

First time Eagtree user with V4

Searching forum returned no results, so hopefully one of you can help.

I want to install the logger in a boat that has a brushed motor and an ESC that allows forward and reverse. The V4 instructions specify the motor side red wire should connect to the positive pole on the motor. That pole becomes negative in reverse direction.

How will the V4 react? I am just logging VOLTS, AMPS, and MAH values. Will I get absolute totals or subtractions.......or a puff of smoke?

The boat has a car type motor and runs on a 2S-4900 mah Lipo.

Thanks for any advice or warnings!

Jim
Jim Blanchfield is offline Find More Posts by Jim Blanchfield
Reply With Quote