View Single Post
Old Sep 04, 2012, 12:30 PM
seearestacey is offline
Find More Posts by seearestacey
Keep Calm, and Carry On...
seearestacey's Avatar
United States, UT
Joined Feb 2012
462 Posts
Quote:
Originally Posted by Billj747 View Post
After printing out and going over all the posted diagrams, I still have 3 unanswered questions:

1 - UBEC getting power between Battery and eLogger or between eLogger and ESC?
(I know this is still up for debate, but no one has objectively answered if the mAH useage of the Rx and servos will still be recorded even if the UBEC is before the eLogger)

2 - When using a UBEC to power the Receiver and servos: Do you remove power AND ground between the ESC and the Throttle output of the OSD Pro? (so only signal is going from OSD to ESC) or can you leave the ground there as well?

3 - When using a UBEC, do you tie into the battery's power AND ground like the manuals for the UBEC state? (Some have recommended ONLY connecting the UBEC to the power side of the battery and the power pinout to the receiver.


Clarification would be greatly appreciated, thank you.
Came across this today: http://www.rcgroups.com/forums/showp...5&postcount=65
not sure if it answers your questions.
seearestacey is offline Find More Posts by seearestacey
Reply With Quote