View Single Post
Old Sep 03, 2012, 07:04 PM
Billj747 is offline
Find More Posts by Billj747
Registered User
Billj747's Avatar
United States, NC, Mooresville
Joined Aug 2012
97 Posts
After printing out and going over all the posted diagrams, I still have 3 unanswered questions:

1 - UBEC getting power between Battery and eLogger or between eLogger and ESC?
(I know this is still up for debate, but no one has objectively answered if the mAH useage of the Rx and servos will still be recorded even if the UBEC is before the eLogger)

2 - When using a UBEC to power the Receiver and servos: Do you remove power AND ground between the ESC and the Throttle output of the OSD Pro? (so only signal is going from OSD to ESC) or can you leave the ground there as well?

3 - When using a UBEC, do you tie into the battery's power AND ground like the manuals for the UBEC state? (Some have recommended ONLY connecting the UBEC to the power side of the battery and the power pinout to the receiver.


Clarification would be greatly appreciated, thank you.
Billj747 is offline Find More Posts by Billj747
Reply With Quote