Originally Posted by victapilot
I believe the graphics processor IC in the V1 has composite video out capability, but it was not enabled by the developer. It's in the processor specs posted earlier, as I recall. Not supported by hardware or firmware.
Originally Posted by flyandi
Ok thanks! I think have to get the #16 :-)
Cheap mini camera for my tiny FPV system :-)
All three cameras, #11, #18 and #16 have the same processor. Unfortunately the video-out pin, which is situated underneath the processor, was left unconnected on the #11 V1. Hence it is impossible to connect to this pin without removing the processor.
I believe the circuit layout of the #11 is identical to that of the #18, although apparently there is some sort of dongle to prevent #18 firmware running on the #11 V2.
flyandi, that's a good choice, IMO