Thread: Build Log Duet Beta Build
View Single Post
Old Sep 01, 2012, 11:15 AM
Mark Miller is offline
Find More Posts by Mark Miller
Registered User
Mark Miller's Avatar
United States, WI, Waunakee
Joined Oct 2002
2,800 Posts
Gordon,

There should be 3/16" shear web that goes between all of the ribs in the center panel except for the joiner boxes where the tips plug in. You can put some epoxy to fill the 1/32" gap. Or you can add a 1/16" piece of balsa to fill the gap. In the full production kits the shear webs will be full width (1/4") where the ply joiners are.

Yes, You will need to slot the ribs for the doubler to slide in. Production kits will have the rib pre cut.

Mark
Mark Miller is offline Find More Posts by Mark Miller
Last edited by Mark Miller; Sep 01, 2012 at 11:46 AM.
Reply With Quote