Thread: Build Log 1/6 Scale Ultralight
View Single Post
Old Aug 31, 2012, 09:52 PM
Marked is offline
Find More Posts by Marked
Registered User
Marked's Avatar
United States, FL, Titusville
Joined Jan 2001
505 Posts
WELL....I hope this doesnt look too goofy looking.....

I had to make the motor look sort of real,so I spent about 12 hours on this part..again ....never thought it takes this much time,but everything is scratch built...

The intake is made from 1/4" wood dowel ,exhaust is from a thin plastic container and some Plastistrut tubes.

I had to paint the motor to match,and added the end screens so the ESC will get some cooling(its hidden in the cylinder head area)

I used thin stiff wire to hold the intake and exhaust assemblies to the case,twisted inside and glued. Holds well.
Marked is offline Find More Posts by Marked
Reply With Quote