View Single Post
Old Aug 30, 2012, 04:21 PM
stgdz is online now
Find More Posts by stgdz
VOLTS > AMPS
stgdz's Avatar
United States, MN, Buffalo
Joined Jul 2011
4,007 Posts
Well yeah, its a geometry issue. You are limited in the pull direction as you get farther and farther on the pull side the geometry gets to the point where it wants to pull the horn out of the surface. Since its glued in the servo, especially digitals, will keep trying to pull before it burns up or browns out the receiver.

You want to setup the surface so that its a bit before this, measure it and then apply a push to the servo so that its equivalent in throw to the pull direction.
stgdz is online now Find More Posts by stgdz
Reply With Quote