View Single Post
Old Aug 29, 2012, 05:28 PM
AEA737 is offline
Find More Posts by AEA737
Registered User
AEA737's Avatar
Joined Jul 2012
51 Posts
Quote:
Originally Posted by seadog1967 View Post
Haven't seen anything related to this. I'm about to get the ET system but I'm putting it on a quad not a plane so am confused a little. Everyone is showing connection to ESC but in my case with the quad I have four esc's. (Flying a Naza Quad). Do I connect to any special one or just connect and since the DJI Naza frame has a built in power distribution setup all my esc's are wired to the frame. Would I just connect the eagle tree to one of the esc's contact points?
Thanks in advance.
Seadog.
Hi Seadog.
Leave the four ESC of your quad as they are. You only need to connect the ESC if you have an airplane with a single motor.
I fly a Naza Hexa and in the process of installing my FPV gear and ET OSD and eLogger. Still figuring out the wiring also.

Javier
AEA737 is offline Find More Posts by AEA737
Reply With Quote