View Single Post
Old Aug 29, 2012, 09:28 AM
T J Gilbert is offline
Find More Posts by T J Gilbert
DJI and Empire Support
T J Gilbert's Avatar
United States, MS, Ridgeland
Joined Feb 2009
6,409 Posts
Quote:
Originally Posted by kryptoknight View Post
My K6 3700 mAh is slightly puffing but it can still last more than 10 mins. The only thing I didn't do is re callibrate the voltage settings on the dji software whenever I switch from my 3700mAh to GEN ACE 4000 mAh before flying again. I checked the voltage reading on my GEN ACE after it went on protection mode and its reading around 11.6V after 5 mins. Fully charged at 12.6 volts. My kypom 3700 mAH was reading 13V on Dji callibration fully charged. It was reading at 12.6V on my ACCUCEL balance charger when it was full. I set the first level protection to 10.6V and 2nd level protection at 10V. So if switching from 3700 mAh to 4000 mAh battery, should I re callibrate it again and set up the first and 2nd level protection in dji software before flying?
I've been swapping between 3300mAh and 3600mAh with no noticeable effect.
No recalibration.
Got scolded some pages back for this, but everyone's lazy at times...
The small weight difference was taken in stride.
As far as compensating for weight increases, the guy taking the rope airborne was impressive.
Every additional foot he lifted added to the AUW, and the Naza/F450 just kept on hoisting.
T J Gilbert is offline Find More Posts by T J Gilbert
Site Sponsor
Last edited by T J Gilbert; Aug 29, 2012 at 09:36 AM.
Reply With Quote