: Build Log
Wicked Powered 50mm Screamer EDF
View Single Post
Aug 27, 2012
, 11:29 PM
Joined Jan 2002
Here are some photos.
1. No added wire length is needed on the motor/ESC
2. Fan area prep is typical for the wemotec as on the other 50mm models
3. I found the lower hatch was barely glued on so pulled it all off. Makes installation or servo wires and ESC much easier.
4. I did remove a little foam where the ESC is located to make it fit easier.
View all Images in thread
Wicked wemo combo and ESC
Fan area prepped for Wemotec fan
Hatch comes off for easy access.
Notch in fan lip to clear wires.
Fan and ESC installation
Latest blog entry:
Indoor Free Flight columnist for Model...