View Single Post
Old Aug 27, 2012, 04:45 PM
Thetis is offline
Find More Posts by Thetis
Always, against the wind
Thetis's Avatar
United States, IL
Joined Oct 2011
1,079 Posts
BL Test flight

I flew her for few mins and everything was working OK, until came down from hovering 3 feet above ground. Back to the bench and I found out motor B was moved and the pinion was not engaging with the gearI guess I have to find longer screws and use the washers and until then no more flying. What Extreme flyers are using the same screws with not only the washers but along the heat insulation plate under motor B. Daaahh Any clue where can I find longer motor mount screws?
Thetis is offline Find More Posts by Thetis
Reply With Quote