Thread: Discussion RVOSD - V5 - reports
View Single Post
Old Aug 26, 2012, 04:58 AM
ommadawn is offline
Find More Posts by ommadawn
The Flying Circus
ommadawn's Avatar
Adelaide South Australia
Joined Sep 2007
4,336 Posts
Exactly. You need to trim the plane to fly straight and level, then when the trims are set, you enter the a/p and "set neutrals". This is the flight control surface positions the a/p will use to fly level. You must save this before you power off. It must be redone any time you make changes to the aircraft that will effect its flight characteristics.
ommadawn is offline Find More Posts by ommadawn
Reply With Quote