View Single Post
Old Aug 25, 2012, 04:31 PM
nascar1929 is offline
Find More Posts by nascar1929
Head in the clouds
nascar1929's Avatar
United States, NC, Gastonia
Joined Jan 2012
1,091 Posts
Ok. Got my Tarot 450 Pro FBL all put together, gyro programmed, swash leveled and blade pitch spot on!

I took the main and tail blades off to spool it up and check over everything. All looks good. The only thing I noticed was my tail servo was very twitchy during the spool up. Is this going to cause a tail wag during flight or is this normal?

I am ready to take it out for her maiden but want to be sure I don't need to make any changes on the tail before I do. My current settings in my Tx for Gyro Sensor are HH 70% / Rate 30%. The settings in the Tarot software are: on main screen Tail Rotor Gain = 100 under the Monitor tab, Tail gain is HH 36% / Rate mode -36%.

Is there anything I should change or just go for it and see what happens? If it does wag too much, what settings do I need to change to fix it?

Here are some pics.
Name: Tarot 450 Pro 018.jpg
Views: 92
Size: 290.6 KB
Description: Name: Tarot 450 Pro 019.jpg
Views: 87
Size: 202.1 KB
Description:
Name: Tarot 450 Pro 020.jpg
Views: 79
Size: 171.9 KB
Description: Name: Tarot 450 Pro 017.jpg
Views: 86
Size: 280.8 KB
Description:
nascar1929 is offline Find More Posts by nascar1929
Last edited by nascar1929; Aug 25, 2012 at 04:38 PM.
Reply With Quote