View Single Post
Old Aug 24, 2012, 03:40 PM
jcdfrd is offline
Find More Posts by jcdfrd
3DHOG
jcdfrd's Avatar
USA, CA, Aromas
Joined Sep 2010
4,858 Posts
max here are a couple ideas for you to chase down
1,check motor wire connections for cold solder, loose or bad bullet connectors to the motor
2, check motor wires where they come out of the motor for cut or damaged wire insulation causing a short to the case of the motor on one of the phases
3, incorrect timming can cause this also, try changing the timing and pwm rate
4, check esc/ motor compatibility......some motor and esc combo's dont play well together

let us know what you find
jcdfrd is offline Find More Posts by jcdfrd
Reply With Quote