Thread: Discussion Stator coating
View Single Post
Old Aug 23, 2012, 09:30 PM
KKUSA is offline
Find More Posts by KKUSA
Registered User
United States, IN, Indianapolis
Joined Oct 2010
1,030 Posts
Yea, thats lookin good. As with any coating process, make sure your part is clean and oil free.

You could put the hot stator on a dowel and coat the whole thing. The proper dowel would mask the ID surface, then just cut it away. That way you could do it in one shot.

Maybe I will remember tomorrow to get the name of the place we get our small quantity powder from. However, I do believe the HF stuff will be adequate with a bit of experimentation. It sure is cheap enough. That $5 pail will go a loooong way!!!
KKUSA is offline Find More Posts by KKUSA
Reply With Quote